If you've ever had to eject pins from a core that you've just combinated,
You NEED this tool!
Test combinated cores BEFORE you cap them !
Part # QTT-1
|
|
After all pin segments have been inserted you just place
this tool onto the top of the "QU-I.C-LOAD" block.
|
| The "QU-I.C-TEST" tool is universal. Works with ULTRA, Best, Falcon, Arrow, Peaks, Schlage SFIC, Medeco Keymark, and KSP. It works on 5-pin, 6-pin and 7-pin cores as well as partially capped cores that are being re-combinated. |
|
|
|
The unique "trumpet keys" will visually indicate any chamber(s) that may have a problem with proper initial pin seating. With a simple push on them the pin stacks are moved to their normal resting point. |
| With the two units coupled, temporary spring pressure is applied in all chambers so you can test every key. If a problem occurs you can correct it while it's easy to do - without having to punch out any caps and springs. If the core works properly you can then cap it with total confidence. |
|
Additional features:
 |
Compact and lightweight with built-in storage cavities located under end plate |
|
Top of tool has color coded chamber slots, caliper groove, pin pocket and docking area (see "QU-I.C-CHECK" tool) |
|
All sides have grip surfaces for ease in handling |
|
Optional Accessories |
||
|
When this adapter is attached to the original "QU-I.C-TEST" Tool you can test the operation of your cores without having to insert them into the companion "QU-I.C-LOAD" Tool. Adapter includes grip inserts, tactile grooves and a "never gets lost" captive screw for ease of use and installation. It can be installed and removed in seconds. One button head hex cap screw holds it firmly in place. It's NOT permanent! Put it on... Take it off... as often as you desire!
|
|
|
|
View of Adapter attached to the "QU-I.C-TEST" Tool. This now allows those that combinate by holding the core in their hand (not holding it in the Xperinetix "QU-I.C-LOAD" Tool) a quick and easy way to test their combinated cores before they cap them. The thumb screw, shown in the insert photo, has two functions. It holds the core retainer plate onto the "QU-I.C-TEST" Tool and it is also used to add and remove the adapter. The specially machined, properly sized hex tip is always available because it is stored on the "QU-I.C-TEST" Tool. You will never have to look for your allen (hex) wrench set. It is always available when you need it!
|
|
|
|
"QU-I.C-TEST" Tool and its adapter works with all Best, Falcon, Schlage SFIC, Medeco Keymark, Arrow, Peaks, and KSP cores. Additional special cores can be checked by using the optional four-sided turret core retainer plate shown in the photo to the right. The core being tested here is a Best dust cover core. This special turret plate allows ample clearance for the dust cover to be lifted and the core's plug accessed for proper testing. (A close-up of this optional core retainer plate is also shown below.)
|
|
|
|
This four-sided turret (QTE) core retainer plate converts the standard "QU-I.C-TEST" Tool to allow use with more specialized Interchangeable cores. This custom plate is for use with: Best Dust Cover Cores Three spare sides for your future custom needs.
|
|
|
